New polymer mixture creates ultra-sensitive heat sensor
Polymer gels with tunable ionic Seebeck coefficient for ultra-sensitive printed thermopiles
Scientists at the Laboratory of Organic Electronics have developed an ultra-sensitive heat sensor that is flexible, transparent and printable. The results have potential for a wide range of applications - from wound healing and electronic skin to smart buildings.
Research fellow Dan Zhao with the printable ultra-senstive sensor.
Peter Holgersson
The ultra-sensitive heat sensor is based on the fact that certain materials are thermoelectric. The electrons in a thermoelectric material move from the cold side to the warm side when a temperature difference arises between the two sides, and a voltage difference arises. In this present project, however, the researchers have developed a thermoelectric material that uses ions as charge carriers instead of electrons, and the effect is a hundred times larger.
A thermoelectric material that uses electrons can develop 100 μV/K (microvolt per Kelvin), which is to be compared with 10 mV/K from the new material. The signal is thus 100 times stronger, and a small temperature difference gives a strong signal.
The results from the research, carried out by scientists at the Laboratory of Organic Electronics at Linköping University, Chalmers University of Technology, Stuttgart Media University and the University of Kentucky, have been published in Nature Communications.
Dan Zhao, research fellow at Linköping University and one of three principal authors of the article, has discovered the new material, an electrolyte that consists of a gel of several ionic polymers. Some of the components are polymers of p-type, in which positively charged ions carry the current. Such polymers are well-known from previous work. However, she has also found a highly conductive polymer gel of n-type, in which negatively charged ions carry the current. Very few such materials have been available until now.
With the aid of previous results from work with electrolytes for printed electronics, the researchers have now developed the first printed thermoelectric module in the world to use ions as charge carriers. The module consists of linked n- and p-legs, where the number of leg connections determines how strong a signal is produced. The scientists have used screen printing to manufacture a highly sensitive heat sensor, based on the different and complementary polymers. The heat sensor has the ability that convert a tiny temperature difference to a strong signal: a module with 36 connected legs gives 0.333 V for a temperature difference of 1 K.
"The material is transparent, soft and flexible and can be used in a highly sensitive product that can be printed and in this way used on large surfaces. Applications are found within wound healing, where a bandage that shows the progress of the healing process is used, and for electronic skin", says Dan Zhao.
Another possible application is in temperature exchange in smart buildings.
Original publication
Other news from the department science
These products might interest you
Most read news
More news from our other portals
Last viewed contents
First look at how our cells can 'swallow up and quarantine' Zika
Prion fingerprints detected with glowing molecule
Monitoring the corrosion of bioresorbable magnesium - Better prediction of degradation rate of magnesium implants
Unlike rubber bands, molecular bonds may not break faster when pulled
Machine learning reveals the mysteries of thin films at atomic scale - High-accuracy atomistic modeling of amorphous materials
First-ever X-ray attosecond experiment on liquids provides new insights into water’s molecular properties - Theorists explain how X-ray measurement freezes hydrogen motion, with implications on other areas of chemistry
New tagging technique enhances view of living cells
Out-sniffing bomb-sniffing dogs - Tel Aviv University researcher leads development of swift, small, highly reliable sensor to detect explosives
Imperial and Tsinghua University launch seed fund for 'ambitious collaborations'
'Lab on a chip' mimics brain chemistry
3D internal structure of rechargeable batteries revealed for the first time
